When type 30 brake chamber is used, push road of the brake chamber should be installed to hole
no. 1 located on the arm. Installation to hole no. 2 or hole no. 3 causes excessive adjustment. For type 24 brake chamber, automatic brake adjuster with cover plate of space position 6 should be used.
Install brake adjuster according to the instructions above. Otherwise automatic brake adjuster will not work properly on the axle. As shown in figure belowe, space position has been marked on the cover plate.
Caution: The angle formed by the brake adjuster arm and brake chamber push rod should be approximately 90 degrees with brake applied when properly installed.
The push rod yoke and push rod should be adjusted if necessary until these conditions prevail.
All Rights Reserved. | Zhuji Shenchi Auto Parts Factory
Fengqiao lndustrial Area,ZhujiCity,Zhejiang,China | Phone :0086-575-87628536 | Fax :0086-575-87422272