When type 24 brake chamber is used, push road of the brake chamber should be installed to hole no. 2 of the brake adjuster. If you install to hole no. 3, power of the brake chamber will be insufficient resulting poor brake. If you install to hole no. 1, stroke of the type 24 brake chamber will be insufficient resulting poor brake too.
For type 24 brake chamber, automatic brake adjuster with cover plate of space position 3 should be
Install brake adjuster according to the instructions above. Otherwise automatic brake adjuster will not work properly on the axle. As shown in figure 1, space position has been marked on the cover plate.
Caution: The angle formed by the brake adjuster arm and brake chamber push rod should be approximately 90 degrees with brake applied when properly installed...
All Rights Reserved. | Zhuji Shenchi Auto Parts Factory
Fengqiao lndustrial Area,ZhujiCity,Zhejiang,China | Phone :0086-575-87628536 | Fax :0086-575-87422272